ARTP_PROVLAIICE
The ART Pro VLA II is a dual-channel tube vactrol-based studio compressor and levelling amplifier. The Pro VLA II uses an Opto circuit, with a 12AT7 vacuum tube in the signal path. The transformerless design makes the Pro VLA II ideal for sculpting transients and dynamic range. With its soft-knee design, the Pro VLA II will give you smooth musical results in the studio. VU metering and XLR / TRS connectors make for a very professional, intuitive, and cost-effective dynamics processing unit.
Type: Compressors/Limiters
VCA-Less Vactrol Opto-Compression Design
Enhanced Link Mode - While in stereo link mode, channel 1 level control acts as a master output level and channel 2 becomes a balance control between them, - optimizing the Pro-VLA II for use as a mastering tool
Variable Threshold, Ratio & Output Controls
LED Backlit VU Input/Output Level Metering
LED Metering Indicates Both Average Level And Peak Hold
Accurate Ten Segment LED Gain Reduction Metering
+4dBu/-10dBu Mode Switch Optimizes Pro-VLA II For Interface with Professional OR Consumer Grade Components
Active Balanced XLR And ¼-Inch Inputs & Outputs
Toroidal Transformer Reduces Mechanical & Electrical Hum
Equivalent Input Noise: @+4dBu: -99dBu (''A'' weighted) / @-10 dBV: -107dBu (''A'' weighted)
Maximum Attenuation: 30dB
Input Impedance: 10K Ohms
Maximum Input Level: +20dBu (in +4dBu mode) / +10dBV (in -10dBV mode)
Maximum Output Level: +20dB max
Frequency Response: 10Hz to 100KHz (+/- 0.5dB)
Dynamic Range: > 100dB (20-20KHz)
Attack Time: 0.25msec. to 50msec. variable
Release Time: Variable 150ms to 3s
Total Harmonic Distortion: <0.1% (typical)
Slope: Variable 2:1 to 20:1
Dimensions: 3.5” x 19" x 9.2" (8.9cm x 48.3cm x 23.3cm)
Weight: 10.5lbs (4.76kg)